current location: Home  > News

Instructions for draft beer machine

source: author: Release time:2021-11-16

I、Before use, first check the appearance of the machine to see if there is any damage due to long-distance transportation, such as wire falling off, smashing deformation, etc. If there is no damage, the equipment can be turned on.
2、 It cannot be used when the voltage is too high or too low. It cannot share a power socket with other electrical appliances. The power socket must be connected with ground wire.
3、 The water tank shall not be filled too full. In order to avoid the danger of electric leakage caused by wetting the electrical components in the machine after overflow.
4、 To maintain good ventilation in the machine, the machine shall be placed at a practical distance from the wall. Do not stick the poster on the air vent of the casing, resulting in overheating or even burning of the compressor.
5、 For whatever reason, after stopping the operation of the equipment, do not start it immediately. Turn off the refrigeration power switch and start the refrigeration power switch after 5 minutes.
6、 Often clean the dust and sundries on the condenser suction net with CO2 gas or broom to maintain stable and good heat dissipation effect.
7、 Equipped with adjustable temperature controller, turn the knob clockwise to reduce the temperature of the water tank, otherwise it becomes higher, and the user can debug it as needed.
Eight the low pressure part of the.CO2 meter should not exceed 0.2 MPa. The joints of the wine pipes and the gas pipes and components must be fasten with clips or wire, otherwise there will be air leakage, excessive leakage of wine and excessive bubbles in the wine.
9、 Do not open the baffle during use to prevent electric shock. Professional staff should be invited to conduct inspection and maintenance.
10、 Be careful when discharging water from the water tank. Do not pour water into the bottom panel or on the conductor to prevent electric leakage, electric shock and other accidents.
11、 For water pump power switch and refrigeration power switch, press "-" to open and "O" to close.
12、 Opening method of distributor: pull the handle first, then lift it up, otherwise close it.