current location: Home  > News

Correct installation process of draft beer machine

source: author: Release time:2021-12-07

The draft beer machine can avoid the contact between beer and air. The beer passing through the draft beer machine has a cool taste and no aging smell. To better apply the draft beer machine, pay attention to the installation of the draft beer machine. The actual operation steps are as follows:
1. Disassemble the package, take out the spare parts and inject clean drinking water to effectively ensure that there is no evaporator and stainless steel coil.
2. Remove the screw cap at the bottom of the wine column, insert the fixed bolt into the corresponding hole of the machine cover, install the screw cap and lock the wine column. Then put the closed ferrule joint into the fully transparent wine pipe, scald the end and tail of the wine pipe with boiling water above and below 70 ℃, insert it into the wine outlet of the stainless steel coil (at least 5cm), and lock the closed card.
3. Insert the closed ferrule connector into the lifting plastic hose and respectively into the air inlet of the distributor and the bottom pressure exhaust port of the CO2 pressure reducer.
4. Point the screw cap of CO2 pressure reducer to the cylinder connector, turn the screw cap and lock it with a wrench. Turn the pressure transformation knob to the deepest position in the reverse direction, turn on the power switch of the gas cylinder, slowly turn the pressure transformation knob clockwise, and adjust the gauge needle (output working pressure) of the bottom pressure gauge to 0.2 ~ 0.3MPa.
5. Install the distributor on the draft beer machine, tighten it clockwise and press down the distributor handle.